Site Home  »  Getting Started »  MSP Ports and Firewall Settings

MSP Ports and Firewall Settings

Tags:  

Ports and Firewall Settings


Default Ports

The default ports that are used by MSP Center Plus are as follows:
MSP Central


MSP Probe


Firewall Settings
IF the Central is Behind Firewall - configure firewall to allow inbound/outbound access for the following ports
  • 443 
  • 8080
IF the Probe is Behind Firewall - configure firewall to allow inbound/outbound access for the following
ports
  • 443
Note: All the Ports are TCP Ports

Changing the default ports

If any of the default port is occupied, then you change the port. Follow the steps given below to change the port number:
  1. Stop the Central/Probe Server, whose port number you want to change
  2. Open the ports.properties file [<Central/Probe home>\conf].
  3. Change the required port number.
  4. Save and close the file.
  5. Start the Central/Probe Server.



 RSS of this page

rtttrrb